Do harm to screw type air compressor dry machine dry, what is the actual effect bad
Source: essens air compressor Time of publication: June 21, 2020 tag： 【 Small in large 】
The factors of poor drying effect of screw type air compressor dryer are as follows
1、 Absorbent crushing
1. The impact friction in the middle of the absorbent is more serious, and the absorbent capacity is reduced;
2. The absorbent dust is easy to block the muffler of the dryer and the pipe filter of the rear camera, which leads to the reduction of the suction efficiency of the filter device.
2、 The cyclones are all over the place
In general, the diameter of the air inlet of the dryer is much smaller than that of the suction cylinder. Under the mutual effect of the original working pressure and velocity, the cyclone usually converges and the vapor distribution is unbalanced according to the filling material in the container.
At this time, a very large number of fillers can not be fully used, which leads to the absorption blind area, which leads to a significant reduction in the utilization rate of absorbent and the reduction of absorption efficiency.
3、 It is very difficult to ensure that the carbon molecular sieve is well proportioned and inseparable due to the large volume and deep structure of the adsorption tower.
If the tunnel is not well proportioned, the effect will be more serious.
Once the tunnel construction occurs, the air compression accelerates according to the speed, and the moisture can not be absorbed completely, so the air compression has already been based on, leading to the significant reduction of the actual suction effect and the rise of leakage points.
Essens air compressor: http://martincountyhistoricalsociety.com
mobile phone: thirteen billion five hundred and fifty-two million five hundred and thirty-five thousand eight hundred and twenty-six
Email: [email protected]
Address: Building 4, yard 49, Badachu Road, Shijingshan District, Beijing